ANALISIS RASIO DAN ERROR DARI PENGGUNAAN PROGRAMMABLE LOGIC CONTROLLER (PLC) SEBAGAI PROTEKSI OVER VOLTAGE DAN UNDER VOLTAGE PADA TEGANGAN 1 PHASE

Authors

  • Gerard Tambingon Politeknik Negeri Manado
  • Johanis Putra Tampemawa Politeknik Negeri Manado
  • Arnold R Rondonuwu Politeknik Negeri Manado
  • Johan F Makal Politeknik Negeri Manado

DOI:

https://doi.org/10.23969/jp.v11i02.53648

Keywords:

Protection System, Over Voltage, Under Voltage, PLC

Abstract

Overvoltage and undervoltage protection systems are essential to maintain the reliability and safety of electrical equipment, considering that the acceptable voltage tolerance is typically limited to ±5% of the nominal value. This study aims to analyze the performance of a PLC-based voltage protection system through experimental testing under various operating conditions. The testing was conducted by varying the input voltage to simulate overvoltage and undervoltage conditions, with observed parameters including pickup voltage, dropout voltage, Vd/Vp ratio, error value, and time delay. The results show that the Over Voltage Relay (OVR) achieved a Vd/Vp ratio of 98%, with error values decreasing from 0.43% to 0%. Meanwhile, the UnderVoltage Relay (UVR) exhibited Vd/Vp ratios of 98%, with error values decreasing from 1.4% to 0%. Both systems maintained a constant time delay of 0.1 seconds, indicating f          ast and stable response. The small difference between pickup and dropout voltages indicates good hysteresis characteristics, preventing chattering. Therefore, the proposed PLC-based protection system demonstrates accurate, stable, and reliable performance in protecting electrical systems.

Keywords: Protection System, Over Voltage, Under Voltage, PLC

Downloads

Download data is not yet available.

Downloads

Published

2026-06-20